Karata Intimidator® Belt Drives
Main Belt Drive PageSoftail Belt DrivesSoftail Belt DrivesXCD Belt DrivesDyna Belt Drives FXR Belt DrivesRoad King Belt DrivesShovelhead Belt DrivesPanhead Belt DrivesKnucklehead Belt DrivesKick Start Belt Drives

INTIMIDATOR PRIMARY BELT DRIVES - ROAD KING

1994 -up LEFT-SIDE DRIVE: 3”, 4” WIDTHS
 INTIMIDATOR ROAD KING 4.0 inch primary belt drive 1994 - up
INTIMIDATOR ROAD KING 4.0" primary belt drive
shown with optional 40097 ‘Hubcap’ front pulley cover and 40099 ‘Hubcap’ rear pulley cover
1994-200116458
2002-up16460
 INTIMIDATOR ROAD KING 3.0 inch primary belt drive 1994 - up
INTIMIDATOR ROAD KING 3.0” primary belt drive
shown with optional 40097 ‘Hubcap’ front pulley cover and 40099 ‘Hubcap’ rear pulley cover
1994-200116457
2002-up16459
 INTIMIDATOR COMPLETE BELT DRIVE KIT
 
INTIMIDATOR ROAD KING BELT DRIVE KIT
All INTIMIDATOR belt drive kits are complete as shown above and described below.
Note: plate shown is for illustrative purposes only
 INTIMIDATOR ROAD KING 3.0 inch primary belt drive
INTIMIDATOR 3.0” ROAD KING primary belt drive
1994 - 2001 16457
2002 - up 16459

DEDICATED ROAD KING DESIGN
Not just for Softail and Dyna models, primary belt drives are available for Road King models in two sizes, beefy 4” and traditional 3”. These belt drives are designed to fit Evolution and Twin Cam Road King models from 1994-present.

Road King primary belt drive kits are available with motor plates specifically designed for Road King models. To allow the continued use of floorboards and OEM foot controls, has machined a bushing boss into the motor plate to allow use of the OEM foot shifter. This innovation is another example of commitment to designing and manufacturing the widest selection of primary belt drives available.

outboard bearing support system is an ideal option for 3” and 4” belt drives. See Outboard Bearing Supports [OBSS] for the wide assortment of ROAD KING Outboard Bearing Support plates and cover combinations available.

ALL INTIMIDATOR SERIES PRIMARY BELT DRIVES INCLUDE THE FOLLOWING:
  • One-piece billet aluminum motor plate with sealed mainshaft bearing, installed
  • Billet aluminum jackshaft support
  • Billet steel starter jackshaft
  • Front pulley with steel retaining ring
  • Rear pulley with ring gear and double-row clutch hub bearing, installed
  • Goodyear Hibrex with Flexten Plus technology 8mm belt
  • Engine shaft nut
  • All necessary hardware included

 

Karata Enterprises Co
3 River Road
Conshohocken, PA 19428
Phone 610-825-2070
Fax 610-941-6142
[email protected]